Description
Precisely executed lifting holes in sheet piles create optimal attachment points for safe and efficient handling throughout the entire construction process. They are specifically adapted to the requirements of modern lifting and installation techniques.
The holes are produced as standard in the pile back. On request, the position and design can be adjusted project-specifically deviating from the standard execution. The holes can also be omitted in case of corresponding project requirements.
The sheet piles prepared in this way can be easily picked up, positioned and installed into the ground using common lifting and installation equipment – in particular vibrators.
The holes are produced as standard in the pile back. On request, the position and design can be adjusted project-specifically deviating from the standard execution. The holes can also be omitted in case of corresponding project requirements.
The sheet piles prepared in this way can be easily picked up, positioned and installed into the ground using common lifting and installation equipment – in particular vibrators.
Advantages
- Precise positioning of lifting holes
- High safety during lifting and installation
- Compatibility with a wide range of vibration and installation techniques
Key data
The standard hole spacing for hot-rolled sheet piles is, measured from the top edge, 75 mm or 300 mm with a hole diameter of 40 mm.
In case of project-specific requirements, the number, position and dimensions of the holes can be individually adjusted.
In case of project-specific requirements, the number, position and dimensions of the holes can be individually adjusted.
Specification
- Product number
- D102